Andover Programmers Toolbox

OPC Server

	CSE OPC is an OPC Data Access 2.0 OPC server. It will serve point values to OPC clients and allow OPC clients to modify point values from the following systems: Andover AC256/AC8 Andover Continuum/Infinity via an available comport on the panel. (Command line support is NOT required) BACnet/IP or BACnet PTP networks LonWorks networks using the Echelon OpenLDV Modbus RS-232/485 (ASCII or RTU) Intelligent Lighting Controls systems
The CSE OPC server will act as an OPC server for any of these systems but only one of them per installation. It is currently not possible to connect to multiple sites or run multiple copies of the OPC server on the same computer. Download the 30-day Evaluation Version Note to Catalyst Pro users: The OPC server uses the same drivers as Catalyst Pro. It is recommended that the two programs not be installed on the same computer. It is possible to run them both on the same computer but if you un-install one of them you will need to re-install the other. No settings will be lost if you re-install either program over the top of itself. Running both programs on the same computer requires that you have Catalyst Pro version 1.7 installed. You may also need to temporarily remove the USB key to run the OPC server in evaluation mode.

Home Catalyst Pro CatNet APT Development CSS OPC Contact